Craft
The art is in the detail.
What SARTO delivers is made in the Limani workshop. Here things are measured, chosen, cut and joined.
Veneer
Laid by picture, not by number.
Veneer is laid so the figure runs across the whole front. Stone is cut along the vein, metal chosen by tone.
Joint
Where two surfaces meet.
Mitre, shadow gap, groove. The joint is the detail you only notice when it is missing.
The hand
The final fit is made by a person.
Machines cut precisely. Fitting on site, checking the surface, adjusting the front remains handwork.
Process
From design to installation.
- 01
Conversation and project review
We read drawings, listen and establish what the room needs.
- 02
Design alignment and material choice
Veneer, stone, lacquer, metal. Decided on the sample, not on screen.
- 03
Technical detailing and approval
Workshop drawings, joint pattern, hardware. Approval before the first board.
- 04
Manufacturing and quality control
Production in the Limani workshop. Inspection before dispatch.
- 05
Delivery, installation and handover
Coordinated with the site. Handed over when everything sits right.
Scope is agreed individually for every project. Not every stage is part of every commission.
Production
From cutting to handover.
- 01
Cutting and veneering
Carrier boards are cut, veneer laid to plan and pressed.
- 02
Joint and edge
Mitres, grooves and edges are made and checked.
- 03
Surface
Sanding, oiling, lacquering. The surface is built up in several passes.
- 04
Pre-assembly and inspection
Carcasses are assembled and checked in the workshop before they leave.
- 05
Transport and installation
Packed, delivered, installed. Coordinated with the site.
Tell us about your project.
A single bespoke piece, a coherent interior concept or a larger package for several units: we reply with a first assessment.